Bed Frames
|
FULL/SEMI ELECTRIC BED FRAME THE REMOTE IS NOT FUNCTIONING 1. Unplug the bed from the outlet to reset the bed. 2. The cord from the remote must be attached to the control unit located under the bed. THE BED SOUNDS AS THOUGH IT IS WORKING, BUT WILL NOT MOVE 1. Check the stopper button on the shaft at the bottom of the bed. The shaft is a pole that runs the full length of the bed; head to foot. Where those 2 sections meet, there is a connection button that must be pushed.
JOERNS LOW BED
WILL NOT RAISE OR LOWER 1. Unplug the bed from the outlet to reset the bed. 2. The cord from the remote must be attached to the control unit, located under the bed.
WHEN RAISING THE HEAD OF THE BED THE POWER SHUTS OFF
1. Make sure the bed is pulled away from the wall a few inches to leave clearance for raising and lowering the bed. In the lowest setting, the bed frame may sit below most outlet receptacles. If this is the case and the bed is pushed too close to the wall; when the bed is lowered it may unplug or cut the power cord.
If the problem persists please contact us. |
|
